Slide Set-Up

From APL
Revision as of 15:59, 25 April 2014 by Wikiuser (talk | contribs) (Created page with "1.<p>500px Place lens tissue paper above and below a microscope slide.</p> 2.<p>500px To clean the ...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
1.

Optical tweezer slide 1.jpg Place lens tissue paper above and below a microscope slide.

2.

Optical tweezer slide 2.jpg To clean the slide, drop a small amount of isopropyl alcohol on top of the top piece of lens tissue.

3.

Optical tweezer slide 3.jpg Slide the lens tissue across the microscope slide, making sure that the alcohol wipes across the entire slide. You may need something to hold the slide in place to keep it from... well, sliding.

4.

Optical tweezer slide 4.jpg Cut a short piece of double sided sticky tape. Cut this piece in half length-wise so you get two, skinny pieces of tape.

5.

Optical tweezer slide 5.jpg Put some vaseline on one side of both pieces of tape.

6.

Optical tweezer slide 6.jpg Place both of these pieces of tape on the microscope slide about a centimeter away from each other with the vaseline sides facing each other.

7.

Optical tweezer slide 7.jpg After cleaning a microscope cover slip in the same fashion as the slide, place a cover slip on top of the two pieces of tape. Be sure that the cover slip is secure.

8.

Optical tweezer slide 8.jpg Retrieve around 10 micro-liters of microsphere solution. Make sure that this is very dilute. If you can see any opacity, it is too concentrated.

9.

Optical tweezer slide 9.jpg


10.

Optical tweezer slide 10.jpg Dry off any excess solution on the edges of the cover slip.

11.

Optical tweezer slide 11.jpg Use top coat nail polish to seal the ends of the channels.

12.

Optical tweezer slide 12.jpg

13.

Optical tweezer slide 13.jpg Yay!