Slide Set-Up

From APL
Revision as of 14:39, 7 December 2014 by Wikiuser (talk | contribs)

Jump to: navigation, search

Back to main Optical Tweezers Page.

1.Optical tweezer slide 1.jpg

Place lens tissue paper above and below a microscope slide.

2.Optical tweezer slide 2.jpg

To clean the slide, drop a small amount of methanol on top of the top piece of lens tissue.

3.Optical tweezer slide 3.jpg

Slide the lens tissue across the microscope slide, making sure that the alcohol wipes across the entire slide. You may need something to hold the slide in place to keep it from... well, sliding.

4.Optical tweezer slide 4.jpg

Cut a short piece of double sided sticky tape. Cut this piece in half length-wise so you get two, skinny pieces of tape.

5.Optical tweezer slide 5.jpg

Put some vaseline on one edge of both pieces of tape. Make sure that you put on as little vaseline as possible while still coating the entire edge.

6.Optical tweezer slide 6.jpg

Place both of these pieces of tape on the microscope slide about a centimeter away from each other with the vaseline sides facing each other. Possibly coat (and let dry) the slide with a Bovine Serum Albumin (BSA) solution (to help prevent microspheres sticking irreversibly to the glass slide)

7.Optical tweezer slide 7.jpg

After cleaning a microscope coverslip in the same fashion as the slide (and possibly coating with BSA), place a coverslip on top of the two pieces of tape. Be sure that the cover slip is secure.

8.Optical tweezer slide 8.jpg

Retrieve around 10 micro-liters of diluted microsphere solution. Make sure that this is very dilute. For example, if you have a starting liquid microsphere solution with 10% solids, shake the original bottle to evenly disperse the beads then try a dilution of ~ 200:1 of deionized water (you may need to dilute even more). If you can see any opacity, it is too concentrated.

9.Optical tweezer slide 9.jpg

10.Optical tweezer slide 10.jpg

Dry off any excess solution on the edges of the cover slip. Cut away excess tape with an exacto knife or scalpel.

11.Optical tweezer slide 11.jpg

Use top coat nail polish on all edges of the cover slip to seal it down.

12.Optical tweezer slide 12.jpg

Let this dry.

13.Optical tweezer slide 13.jpg

Yay!

Important notes:

  • Make sure to orient the slide so that the cover slip is facing towards the objective lens. In our case, the working distance of our objective lens is 0.2 mm. If your's is similar, the sample will be too far away to focus.
  • Take special care when applying nail polish near the microscope slide edges. If there is nail polish where the slide contacts the grooves of the slide mount, the nail polish may cause jamming or dry inside the grooves.
  • To conserve microscope slides and to produce more stability, cleaving standard sized microscope slides into halves is a good idea.