Operating a Milling Machine

From APL
Revision as of 14:26, 30 April 2018 by Bsboggs (talk | contribs) (Activities)

Jump to: navigation, search
Grizzly G0759


Permanent Materials

- G0759 Milling Machine and Milling Vise
- Collets
- HSS Mills
- Drill Chuck and Drill Bits
- Die and Tap Sets
- Edge Finder
- Dial Indicator
- Parallel Bar Set
- Digital Calipers

Consumable Raw Material

- Al 6061 1 1/8" x 1 1/8" Bar Stock

Activities

Basic Idea: Make a small 1" Al cube with tapped holes and one face hogged out.

CLEAN UP AREA AFTER EACH LAB SESSION

  1. Get a safety demonstration from the instructor or TA.
  2. Read the G0759 manual Introduction and Safety sections (pages 2-10) and the Operations section (pages 22-32).
  3. Use AutoCAD (on virtual machine on mother in APL) to make a technical drawing of a 1" Al cube with four 8-32 (0.5" deep) tapped holes in the corner of one face (holes positioned 1/8" from edges) and a 1/4" hogged out squarish hole (1/8" border) on the opposite face. If you're new to AutoCAD you can view a few of the many good AutoCAD-for-beginners tutorials on YouTube.
  4. Calculate Spindle Speed with this online calculator. Set the mill's spindle speed to be no more than 3/4 the calculated speed and less than 80% of the maximum G0759's spindle speed.
  5. Set up a rough cut of a ~ 1 1/8 length section from the Al bar stock using the band saw - Get instructor or TA approval before making the cut. Clean up metal shavings and put bandsaw and stock back in storage areas.
  6. Mount the rough block in the milling vise using parallel bars (rough side face up)- Get instructor or TA approval before milling.
  7. Face mill the rough side so that it's 1.000" +- 0.003" from its opposite face.
  8. Side mill the other faces such that all faces are 1.000" +- 0.003" from their opposites (use edge finder to precisely locate faces). Get instructor or TA approval before making first side mill operation.
  9. Use dial indicator to verify that the faces are parallel to within 3 mils (a mil is one thousandth of an inch).
  10. Drill and tap 4 8-32 screw holes at the corners of one face (1/8" in from both faces). Use this drill and tap chart. Discuss this procedure with instructor or TA before attempting.
  11. Hog out the face opposite to the tapped holes. Leave 1/8" border and hog to 1/4" depth (make the process easier with a pattern of material-removing drilled holes). Discuss this operation with the instructor or TA before attempting.
  12. Put all tools back into storage and clean up area.