Difference between revisions of "How to Test Transistors and FETs"

From APL
Jump to: navigation, search
Line 8: Line 8:
  
 
[[File:Front.jpg]]
 
[[File:Front.jpg]]
 +
 +
 +
== Getting the Settings Right ==
 +
Once you have properly inserted the component you are testing, you can turn on the Curve Tracer. Once booted up, the curve tracer will come up with a menu.
 +
[[File:IMG_1062.JPG]]  [[File:IMG_1063.JPG]]

Revision as of 08:54, 25 May 2017

To test transistors and FETs, we use the Tektronix 571 Curve Tracer.


Setting up the Curve Tracer

First thing you need to do is determine which pin your emitter, collector, and base are if you are testing a transistor, or if you are testing a FET which pins are gate, source and drain. You then insert the component you are testing into the proper slot on the curve tracer making sure each pin is going in its designated location. Once the component is properly inserted into the Curve Tracer there is a cover you can slide over the device, just in case because the components can get very hot during testing.

Error creating thumbnail: convert: unable to extend cache `/var/www/wiki/images/7/70/Front.jpg': File too large @ error/cache.c/OpenPixelCache/3680.
convert: no images defined `/tmp/transform_31f4f7a77898.jpg' @ error/convert.c/ConvertImageCommand/3210.

Error code: 1


Getting the Settings Right

Once you have properly inserted the component you are testing, you can turn on the Curve Tracer. Once booted up, the curve tracer will come up with a menu. Université du Québec en Outaouais, Lucien-Brault.jpg File:IMG 1063.JPG