General Lab Equipment Obstacle Course

From APL
Revision as of 12:07, 13 January 2016 by Wikiuser (talk | contribs) (Multimeters)

Jump to: navigation, search

A general primer in important equipment in a scientific laboratory.


Multimeters

This module will teach you about how to use the Fluke 179 True RMS multimeter. For this, you will need:

  • Rigola DP1308A DC Power Supply
  • Rigola DG1022 Function Generator
  • An assortment of short wires
  • 3 Resistors: 10ohm, 50ohm, 200ohm
  • 4 Capacitors:
  • A diode:

You'll learn more about the Power Supply and Function Generator later, but we'll need a minimum of functionality from them to make measurements with the multimeter.


  • Measuring voltage
    1. Measuring current (check that fuse isn't blown!)
    2. Measuring resistance and testing for continuity
    3. Diode check
    4. AC signals, frequency response
    5. Capacitance
    6. Clamp meter
    7. </ul>

      Power Supplies

      • Digital and Analog
      • Floating and grounding
      • Current/voltage limiting

      Function Generators

      (Should look at this in tandem with the following oscilloscope discussion)

      • Frequency, amplitude, offset, phase
      • Frequency sweep/ramp
      • Sine, square (incl. TTL), triangle, sawtooth, arbitrary waveforms (possibly a demonstration of Fourier components)

      Oscilloscopes

      • Voltage/time scale
      • Coupling
      • Triggering
      • Scope probes
      • Termination
      • Bandwidth, sampling
      • Aliasing
      • Analyzing data: cursors, averaging, math menu
      • Exporting data
      • Analog and digital scopes

      RF Signals

      • Measuring RF power
      • Termination and impedance matching
      • Attenuation and filtering
      • Splitters, mixers, and switches

      Lock-in Amplifier

      • Basic idea of operation; reason for using
      • Use switch to turn on and off a highly attenuated signal and detect it with the lock-in

      Frequency Counters

      Measure the frequency of an RF source; map frequency vs. voltage curve of a voltage controlled oscillator (VCO)

      RF Spectrum Analyzer

      Always be careful to ensure signal input to spectrum analyzer is not too large

      • What does a spectrum analyzer do?
      • Attach wire-loop antenna and find radio stations
      • Mix two RF signals and observe the expected spectrum
      • Measuring amplitude of signal above background
      • Save and export data

      Soldering

      • Soldering technique
        • Cleaning iron tip
        • Heat pieces to be soldered (hot iron, short time)
        • Avoid cold solder joints
        • Look for shiny and smooth result
      • Tools of the trade: heatshrink tubing, desoldering pump, solder wick, wire strippers, soldering gun, heat gun, rosin flux
      • Solder end of DB9 cable (using only 4 or 5 conductors) to practice stripping wire, using heatshrink tubing, and creating usable product
      • Construct voltage divider on perfboard with BNC input/output connectors