Difference between revisions of "Fiber-Optics Obstacle Course"

From APL
Jump to: navigation, search
Line 1: Line 1:
 +
* When working with bare fibers or lasers wear appropriate safety (or laser) goggles. If you're unsure about this please consult the instructor or lab TAs.
 +
 
- Read the first 4 chapters of John Crisp's eBook, "Introduction to Fiber Optics". Consult remaining chapters as needed.
 
- Read the first 4 chapters of John Crisp's eBook, "Introduction to Fiber Optics". Consult remaining chapters as needed.
  
 
- Look over the APL's Fiber Optics Wiki page [[Fiber Optics]] and links therein.
 
- Look over the APL's Fiber Optics Wiki page [[Fiber Optics]] and links therein.
  
- Consulting Thorlab's Fiber Polishing Manual [[Media:FN96A-Manual.pdf| Fiber Polishing and Connectorization]] and the (above mentioned) eBook construct a 1 meter SM FC-APC to FC-APC fiber patch cable (you will find everything you need at the fiber polishing station). [[File:Fiber_station.jpg| right|500px]]
+
- Consulting Thorlab's Fiber Polishing Manual [[Media:FN96A-Manual.pdf| Fiber Polishing and Connectorization]] and the (above mentioned) eBook construct a 1 meter SM FC-APC to FC-APC fiber patch cable (you will find everything you need at the fiber polishing station). [[File:Fiber_station.jpg| right|400px]]
  
 
- Measure power loss through your patch cable.
 
- Measure power loss through your patch cable.
Line 10: Line 12:
  
 
- Measure the power loss through your fusion spliced patch cable.
 
- Measure the power loss through your fusion spliced patch cable.
 
 
  
  

Revision as of 13:46, 6 February 2015

  • When working with bare fibers or lasers wear appropriate safety (or laser) goggles. If you're unsure about this please consult the instructor or lab TAs.

- Read the first 4 chapters of John Crisp's eBook, "Introduction to Fiber Optics". Consult remaining chapters as needed.

- Look over the APL's Fiber Optics Wiki page Fiber Optics and links therein.

- Consulting Thorlab's Fiber Polishing Manual Fiber Polishing and Connectorization and the (above mentioned) eBook construct a 1 meter SM FC-APC to FC-APC fiber patch cable (you will find everything you need at the fiber polishing station).
Fiber station.jpg

- Measure power loss through your patch cable.

- Break your patch cable in the middle and repair it with a fusion splice (see fusion splicer manual Fusion Splicer Manual and eBook.

- Measure the power loss through your fusion spliced patch cable.






- Break the fusion splice out of the patch cord leaving two partly-connectorized fibers.

- Strip and cleave the unconnectorized end of one of the fibers and use the free-space-to-fiber coupler
Fs-fiber coupler.jpg
to couple a free space beam into the SM fiber (our coupler is not quite as that shown at the right).

- Use a 50/50 fiber splitter/combiner to split your fiber coupled beam into two approximately equal beams. Measure the power in each output beam.

- Use a 1550nm Fiber-coupled LD and a 980 nm fiber-coupled LD and a 1550/980 WDM (wavelength division multiplexer) to combine the 980 and 1550 nm sources into a SM fiber.

- Verify that a fiber isolator exhibits low power loss in one direction only.




- Construct an Erbium-Doped SM Fiber Ring Laser. Measure its optical power vs. pump current/power curve. See here for more details

Frl.png